HP A6828A Manual do Utilizador descarregar pdf (Página 71)

Installing the A6828A Adapter

Verifying Installation

Chapter 2 55

Verifying Installation

After installing the adapter and the c8xx driver and attaching the

peripheral devices, verify that all the components are working by

performing the following steps:

Step 1. To verify that the adapter is correctly installed, issue the following

command:

ioscan -fnk

The applicable line in the ioscan output can have the following form:

ext_bus 0 0/0/10/0/0 c8xx CLAIMED INTERFACE SCSI C1010 Ultra160 Wide LVD A6828-60101

The third column shows the hardware path of the PCI device/function

(shown in bold in the above example, for highlighting purposes). The

A6828A supports one PCI device/function (because it has only one

channel). In addition, since this is a single channel HBA, one line is

listed for channel A of the adapter (denoted by a 0 as the last digit in the

hardware path).

Step 2. In the same line of the ioscan output, verify that the adapter is claimed

by the SCSI c8xx driver by looking at the ﬁfth column of information

(shown in bold in the example below, for highlighting purposes).

ext_bus 0 0/0/10/0/0 c8xx CLAIMED INTERFACE SCSI C1010 Ultra160 Wide LVD A6828-60101

If the adapter is not claimed, see “If the A6828A Adapter is Not Claimed”

on page 86.

Step 3. In the same line of the ioscan output, verify that the SCSI driver and

adapter information are displayed (shown in bold in the example below,

for highlighting purposes).

ext_bus 0 0/0/10/0/0 c8xx CLAIMED INTERFACE SCSI C1010 Ultra160 Wide LVD A6828-60101

In this example, the SCSI driver information is c8xx (name of the

driver), and the adapter information is as follows:

• SCSI C1010—The type of HBA (SCSI) and the type of Ultra160

controller (C1010).

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 137 138

Sem comentários

HP A6828A Manual do Utilizador Página 71