Hp Integrity NonStop J-Series Manual do Utilizador descarregar pdf (Página 54)

Troubleshooting

M8605A and M8606A ACL Tape Drive Installation and User’s Guide—546012-002

6-6

Fault Symptom Codes (FSCs)

Undefined Config 3020 C, G In loader, unexpected config, not a

Thunder or Lightning.

Orphan Cartridge not

flowed

3030 C, G The loader could not successfully stow an

orphan cartridge to a bin.

Chassis S/N

Mismatch. Previous

S/N retained

3031 G The serial number scanned from the

barcode label does not match the value

stored in nonvolatile memory.

Chassis S/N

Character count is not

correct

3032 G A valid serial number barcode label could

not be read.

Chassis S/N did not

scan

3033 G A valid serial number barcode label could

not be read

Chassis S/N save

operation failed

3034 G The serial number scanned from the

barcode label could not be saved to

nonvolatile memory.

Motor Firmware Error 3040 C, G The loader task detected an unexpected

status and could not recover (internal

target error).

Loader Received

Invalid Command

3041 C, G The loader task received an unexpected

command and could not recover (internal

target error).

Motor Firmware Error 3042 C, G The loader task detected an unexpected

status and could not recover (internal

target error).

Missing Magazine 3050 F In diag, no magazine installed for diag to

run.

No Cartridges In ACL 3051 F No cartridge available for diag to run.

Too Many Cartridges 3052 F Unable to run cart or drive cycle, loader is

full with cartridges.

Need 1 Drive

Minimum

3054 F No available drive to run diag.

Invalid Magazine Type 3057 F Unsupported Magazine type detected.

Magazine Type

Change Not Handled

3058 F Unsupported magazine type detected.

Drive Type Not

Supported

3059 F Unsupported drive type detected.

Diag Fetch, Drive not

loaded

305b F Diag: No cartridge present for a fetch.

Diag Time-out waiting

for drive empty, ready

305d F Fetch, time-out waiting for drive unload.

Table 6-2. Fault Symptom Codes

Message FSC ERP

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 79 80

Comentários a estes Manuais

Sem comentários

Hp Integrity NonStop J-Series Manual do Utilizador Página 54

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Hp Integrity NonStop J-Series