
A–2 edge switch 2/16 product manager user guide
Product Manager Messages
Are you sure you want to
send firmware version?
Confirmation to add a
firmware version to the
firmware library. The
firmware library can hold
eight firmware versions.
Click Yes to confirm adding
the firmware version to the
firmware library, or no to
cancel the operation.
Cannot enable beaconing
on a failed FRU.
Occurs when selecting
Enable Beaconing option for
a failed FRU.
Replace FRU and enable
beaconing again or enable
beaconing on operating
FRU.
Cannot enable beaconing
while the system error light
is on.
Beaconing cannot be
enabled while the system
error light is on.
Select Clear System Error
Light from Product menu to
clear error light, then enable
beaconing.
Cannot have E_Ports
configured in S/390 mode.
E_Ports are not allowed
when the operating mode of
the system is S/390.
Informational Message.
Configure operating mode to
Open Systems mode
through the Configure
Operating Mode dialog box,
then configure ports as
E_Ports through the
Configure Ports dialog box.
Cannot have spaces in field. Spaces are not allowed in
this field.
Remove the spaces or
retype the field without
spaces.
Cannot install firmware to a
switch with a failed CTP
card.
Firmware cannot be
installed on a switch with a
defective CTP card.
Replace the switch and retry
the firmware install to the
switch.
Cannot perform this
operation while the switch is
offline.
This operation cannot take
place while the switch is
offline.
Configure the switch offline
through the Set Online State
dialog box then retry the
operation.
Cannot retrieve current
SNMP configuration.
The current SNMP
configuration cannot be
retrieved. The link is down
or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Table A–1: HP StorageWorks Edge Switch 2/16 Product Manager Messages
Message Description Action
Comentários a estes Manuais