HP StorageWorks Edge Switch 2/16 Manual do Utilizador descarregar pdf (Página 69)

edge switch 2/16 product manager user guide 2–19

Monitoring and Managing the Switch

Clear Link Incident Alert(s)

Click this to clear the attention indicator on the Hardware View, the Port List View,

and the Performance View. In addition, the procedure clears the alert description in

Port Properties dialog boxes. If there are no link incident alerts set for a port, no

actions occur. Although you can manually clear link incidents, they may also be

cleared by actions outside of the user interface, such as when rebooting the HAFM

server.

Reset Port

Click to display a confirmation dialog box. Click Yes on that dialog box to reset the

port. If a switch is attached to the port and online, this operation sends a link reset to

the attached switch, otherwise this action disables port beaconing for the port. If the

port is in a failed state, such as after failing a loopback test, the reset restores the port

to an operational state, clearing the service required (amber) LED. The reset does not

affect other ports in the switch.

Port Binding

Click to display the Bind WWN dialog box (Figure 2–9). Use this dialog box to allow a

device with a specific WWN or nickname to have exclusive connection to a port. To

use this dialog box, refer to the following paragraphs.

Figure 2–9: Bind WWN dialog box

Bind WWN dialog box parameters:

• Port Binding: Click this check box to place check mark in the box and enable

WWN binding for the port. When enabled, only a specific device can

communicate through the port. This device is specified by the WWN or nickname

entered into the Bound WWN field (either the Attached WWN or WWN options).

With the check box cleared, any device can communicate through the port even if

a WWN or nickname is specified in the Bound WWN field.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 193 194

Sem comentários

HP StorageWorks Edge Switch 2/16 Manual do Utilizador Página 69