HP DL380z Guia do Utilizador descarregar pdf (Página 31)

Installing the PCI riser cage

WARNING! To reduce the risk of personal injury, electric shock, or damage to the equipment, remove the

power cord to remove power from the server. The front panel Power On/Standby button does not completely

shut off system power. Portions of the power supply and some internal circuitry remain active until AC power

is removed.

1. Power down the server, (see Powering down the server on page 16).

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Do one of the following:

●

Extend the server from the rack (see

Extending the server from the rack on page 17).

●

Remove the server from the rack (see

Removing the server from the rack on page 17).

4. Remove the access panel (see

Removing the access panel on page 18).

5. Install the PCI riser cage.

6. Install the access panel (see Installing the access panel on page 18).

7. Install the server into the rack (see

Installing the server into the rack on page 30).

8. Connect each power cord to the server.

9. Connect each power cord to the power source.

10. Power up the server (see

Powering up the server on page 16).

Installing the PCI riser cage 23

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 132 133

Sem comentários

HP DL380z Guia do Utilizador Página 31