HP DL380z Guia do Utilizador descarregar pdf (Página 56)

Removing a hot-plug SAS or SATA hard drive

CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot

covers, or blanks installed. If the server supports hot-plug components, minimize the amount of time the

access panel is open.

1. Determine the status of the drive from the hot-plug SAS drive LED combinations (see Hot-plug drive

LED definitions on page 13).

2. Back up all server data on the drive.

3. Remove the drive.

Universal media bay option

The following procedure provides the steps to install the universal media bay option, route the VGA and USB

cables, and install an optional optical disk drive. The universal media bay option also accommodates the two-

bay SFF front drive cage option.

1. Power down the server (see

Powering down the server on page 16).

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Do one of the following:

●

Extend the server from the rack (see

Extending the server from the rack on page 17).

●

Remove the server from the rack (see

Removing the server from the rack on page 17).

4. Remove the access panel (see

Removing the access panel on page 18).

5. Remove the air baffle (see

Removing the air baffle on page 25).

6. Remove the fan cage (see

Removing the fan cage on page 20).

48 Chapter 5 Hardware options installation

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 132 133

Sem comentários

HP DL380z Guia do Utilizador Página 56