HP DL380z Guia do Utilizador descarregar pdf (Página 68)

12. Connect each power cord to the power source.

13. Power up the server (see

Powering up the server on page 16).

GPU enablement kit

WARNING! To reduce the risk of personal injury, electric shock, or damage to the equipment, remove the

power cord to remove power from the server. The front panel Power On/Standby button does not completely

shut off system power. Portions of the power supply and some internal circuitry remain active until AC power

is removed.

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots

have either an expansion slot cover or an expansion board installed.

To install the component:

1. Power down the server (see

Powering down the server on page 16).

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Do one of the following:

●

Extend the server from the rack (see

Extending the server from the rack on page 17).

●

Remove the server from the rack (see

Removing the server from the rack on page 17).

4. Remove the access panel (see

Removing the access panel on page 18).

5. Remove the air baffle (see

Removing the air baffle on page 25).

6. Remove the standard efficiency air diverters from the air baffle.

60 Chapter 5 Hardware options installation

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 132 133

Sem comentários

HP DL380z Guia do Utilizador Página 68