Hp MPX200 Multifunction Router Manual do Utilizador descarregar pdf (Página 51)

set fc

The set fc command sets the link rate for a specified Fibre Channel port.

Syntax

set fc -port=port number

Keyword

Specifies a new link rate in gigabits per second for the specified Fibre Channel port.

Values are:

-fc_link_rate=

• auto

• 2Gb

• 4Gb

• 8Gb

The default is the current setting on the router.

Example

c:\> rcli set fc -port=1 -fc_link_rate=auto /ip=10.0.0.12

FC Port 1 basic info successfully configured

set fc_adv

The set fc_adv command sets the frame size, execution throttle, and connection type for a

specific Fibre Channel port.

NOTE: You can specify either the -loop_only, -loop_preferred, -p2p_only, or

-p2p_preferred keyword, but not more than one. If none of these keywords are used, the

default is as currently set on the router.

Syntax

set fc_adv -port=port number

Keywords

Specifies the execution throttle value as an integer in the range of 16 to 65535.-exec_throttle=

The default value is set on the router.

Specifies the frame size in bytes. Values are:-frame_size=

• 512

• 1024

• 2048

The default value is set on the router.

Specifies loop-only as the programmed connection option.-loop_only

Specifies loop as the preferred programmed connection option.-loop_preferred

Specifies point-to-point as the programmed connection option.-p2p_only

Specifies point-to-point as the preferred programmed connection option.-p2p_preferred

Example

c:\> rcli set fc_adv -port=1 -frame_size=2048 -loop_preferred

/ip=10.0.0.12

set fc 51

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 119 120

Sem comentários

Hp MPX200 Multifunction Router Manual do Utilizador Página 51