Hp MPX200 Multifunction Router Manual do Utilizador descarregar pdf (Página 83)

Example

c:\> rcli -port=1 /ip=10.0.0.12

[10.0.0.12]

Zone set: CA_101 (FC1)

Zone: My_mpx200_vp1

Port Name 21:0:0:c0:dd:12:f9:5c

Port Name 21:0:0:c0:dd:12:f9:5d

Port Name 21:0:0:c0:dd:12:f9:66

Port Name 21:0:0:c0:dd:12:f9:67

Port Name 50:1:43:80:1:19:5e:4b

Port Name 50:1:43:80:1:19:5e:4e

Zone: My_mpx200_vp2

Port Name 21:1:0:c0:dd:12:f9:5c

Port Name 21:1:0:c0:dd:12:f9:5d

Port Name 21:1:0:c0:dd:12:f9:66

Port Name 21:1:0:c0:dd:12:f9:67

Port Name 50:1:43:80:1:19:5e:4b

Port Name 50:1:43:80:1:19:5e:4e

Zone set: CA_101 (FC2)

Link down -- cannot retrieve zone information

Zone set: CA_101 (FC3)

Link down -- cannot retrieve zone information

Zone set: CA_101 (FC4)

Link down -- cannot retrieve zone information

test notification

The test notification command tests an existing notification profile by sending a trial email

message to the recipients listed in the profile.

Syntax

test notification

Keywords

Specifies the name of a notification profile to be tested.-name

Example

c:\> rcli test notification -name="my Profile" /ip=10.0.0.12

[10.0.0.12]

Notification profile test started OK

tracert system

The tracert system command traces the route from the management port to a specified IP

address.

NOTE: This command does not support the use of iSCSI ports for outbound router tracing.

Syntax

tracert system -ping_ipaddr=IPv4 or IPv6 address

test notification 83

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 119 120

Sem comentários

Hp MPX200 Multifunction Router Manual do Utilizador Página 83