Hp MPX200 Multifunction Router Manual do Utilizador descarregar pdf (Página 59)

Example

c:\> rcli set presented -chap_enable=yes -chap_secret="my password"

-is_target=iqn.1986-03.com.qlogic:fcgw.mpx200.0823e00014.b2.02.50014987625da3

24 /ip=10.0.0.12

CHAP secret successfully enabled for iSCSI Presented Target

iqn.1986-03.com.qlogic:fcgw.mpx200.0823e00014.b2.02.50014987625da324

set snmp

The set snmp command sets the SNMP parameters.

Syntax

set snmp

Keywords

Specifies if authentication is enabled or disabled for SNMP. Values are:-auth_enable=

• yes

• no

• on

• off

• true

• false

The default is the current setting on the router.

Specifies the name of the SNMP system contact.-contact=

The default is the current setting on the router.

Specifies the SNMP system location. The default is the current setting on the router.-location=

Specifies the SNMP read community.-read_community=

The default is the current setting on the router.

Specifies the SNMP trap community.-trap_community=

The default is the current setting on the router.

Specifies if SNMP traps are enabled or disabled. Values are:-trap_enable=

• yes

• no

• on

• off

• true

• false

The default is the current setting on the router.

Specifies an integer in the range of 0 to 7 for the SNMP trap array index.-trap_index=

Default value is 0.

Specifies the IPv4 or IPv6 address for the SNMP trap.-trap_ipaddr=

The default is the current setting on the router.

Specifies the maximum number of SNMP trap ports.-trap_port=

Values are in the range of 1 to 65535.

set snmp 59

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 119 120

Sem comentários

Hp MPX200 Multifunction Router Manual do Utilizador Página 59