
Figure 24 Set iSCSI controller time
Code load
NOTE: HP recommends that you load the latest MPX200 firmware. See http://www.hp.com/
go/hpsc for updates.
You load the firmware from the P6000 Command View Code Load page for the iSCSI controller.
Firmware is loaded for the selected controller only; for a dual-blade configuration, you must perform
this procedure for each blade.
1. Select the desired iSCSI controller.
2. Click Code Load.
3. Browse to the firmware file.
4. Click Next Step.
5. Click Finish.
6. In the dialog box, enter yes, and then click Update.
The MPX200 reboots upon successful load of the firmware.
36 Managing MPX200 iSCSI using HP P6000 Command View
Comentários a estes Manuais