Hp MPX200 Multifunction Router Manual do Utilizador descarregar pdf (Página 65)

Figure 58 Targets tab (Windows 2012, 2008)

c. Select the target IQN noted in Step 4d, and then click Log On.

A dialog box opens.

d. Configure the target IQN.

• Select the Automatically check box to restore this connection when the system boots.

• Select the Multipathing check box to enable MPIO. The target status is Connected

when logged in.

NOTE: HP recommends using the Advanced button to choose the Local Adapter, Source

IP, and Target Portal. The Target Portal IP Address is the iSCSI port that this initiator

connection is defined.

e. Depending on the operating system, open Server Manager or Computer Management.

f. Select Disk Management.

g. Select Action→Rescan Disks. Verify that the newly assigned disk is listed; if not, you may

need to reboot.

h. Format and partition the disk to prepare it for use.

Multipathing

Microsoft MPIO includes support for redundant paths to send I/O from the initiator to the target.

For Windows Server 2008, MPIO is a separate feature that must be installed separately. Microsoft

iSCSI Software Initiator 2.x includes MPIO and must be selected for installation. Setting up redundant

paths properly ensures high availability of the target disk. Ideally, the paths would use separate

Setting up the iSCSI initiator 65

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 257 258

Sem comentários

Hp MPX200 Multifunction Router Manual do Utilizador Página 65