Hp MPX200 Multifunction Router Manual do Utilizador descarregar pdf (Página 99)

• Bidirectional CHAP during discovery session and single-direction CHAP during normal session

• Bidirectional CHAP during discovery session and during normal session

Enabling single-direction CHAP during discovery session and normal session

Table 15 (page 99) lists the settings you use to enable single-direction CHAP during a discovery

session and normal session.

Table 15 CHAP single-direction settings

Microsoft initiator secret settings

MPX200 secret settings

Setting (example)ActionSetting (example)Source

N/AGeneral Tab SecretN/AiSCSI Port

CHAPsecret01Add Target PortalCHAPsecret01Discovered iSCSI Initiator

CHAPsecret01Log on to TargetN/AiSCSI Presented Target

These are examples of secret settings. Configure CHAP using settings that apply to your network environment.

To enable CHAP for the MPX200-discovered iSCSI initiator entry:

• If the iSCSI initiator is not listed when you execute the set chap command, do one of the

following:

◦ From HP P6000 Command View, select Hosts, and then select the Add Host tab. Enter

the IQN string.

◦ From the CLI, use the add command to add the iSCSI initiator that will perform the

discovery.

• If the iSCSI initiator is listed when you execute the set chap command, then enable the

CHAP secret (for example, CHAPsecret01):

1. Select the index of the iSCSI initiator.

2. Enable CHAP by selecting 0 and then entering the CHAP secret.

• To enable CHAP for the Microsoft iSCSI initiator:

1. Click Discovery

• To discover iSCSI target portals manually:

a. Click Add under Target Portals.

b. Enter the IP address of the MPX200 iSCSI port.

c. Click Advanced.

d. Select the CHAP Login Information check box.

e. Enter the CHAP secret for the MPX200-discovered iSCSI initiator in the Target Secret box

(for example, CHAPsecret01).

f. Click OK.

The initiator completes target discovery.

• To discover iSCSI target portals using iSNS:

a. Click Add under iSNS Servers.

b. Enter the IP address of the iSNS server.

c. Click OK.

2. Click Targets, and then select the appropriate target for login.

3. Click Log On.

4. Click Advanced.

5. Select the CHAP Login Information check box.

Setting up authentication 99

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 257 258

Comentários a estes Manuais

Sem comentários

Hp MPX200 Multifunction Router Manual do Utilizador Página 99

Comentários a estes Manuais

Manuais e produtos relacionados com Armazenamento Hp MPX200 Multifunction Router