Hp MPX200 Multifunction Router Manual do Utilizador descarregar pdf (Página 87)

2. Verify that SendTargets is enabled:

# iscsiadm list discovery

3. The MPX200 has multiple iSCSI ports available to the Solaris iSCSI initiator. To discover the

targets available, enter the following command for each iSCSI port IP address that the iSCSI

initiator accesses:

#iscsiadm add discovery-address ‘iscsi port IP address’

4. Verify the discovery address entries:

#iscsiadm list discovery-address

5. After discovery addresses are entered, the Solaris iSCSI initiator polls each address for all

targets available. To list the targets available to the initiator, enter the following command:

#iscsiadm list target

Example:

#iscsiadm list target

Target: iqn.1986-03.com.hp:fcgw.mpx200.0834e00028.b2.01.50014380025c4179

Alias: -

TPGT: 0

ISID: 4000002a0000

Connections: 1

Target: iqn.1986-03.com.hp:fcgw.mpx200.0834e00028.b1.01.50014380025c417d

Alias: -

TPGT: 0

ISID: 4000002a0000

Connections: 1

NOTE: The iSCSI initiator must discover all targets presented by each MPX200 iSCSI port

that will be used in a multipath configuration.

6. Create the iSCSI device links for the local system:

# devfsadm -i iscsi

Modifying the target parameter MaxRecvDataSegLen

Sun recommends that you set the MaxRecvDataSegLen parameter to 65,536 bytes for each

iSCSI discovered target. For more information, see http://wikis.sun.com/display/StorageDev/

iSCSI+Features+Related+to+RFC+3720+Parameters.

To modify the target parameter MaxRecvDataSegLen:

1. List all iSCSI targets:

#iscsiadm list target-param

2. Change the value of MaxRecvDataSegLen to 65536 for each target:

#iscsiadm modify target-param -p maxrecvdataseglen=65536 ‘target

iqn’

Setting up the iSCSI initiator 87

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 257 258

Sem comentários

Hp MPX200 Multifunction Router Manual do Utilizador Página 87