HP Hybrid POS Printer with MICR II Manual do Utilizador descarregar pdf (Página 21)

●

O, normal mode (data scope mode disabled)

●

Data scope mode (enabled)

NOTE: Press the paper feed button for at least one second to validate the selection.

To run the data scope mode:

1. After you have enabled the data scope mode, exit the conguration menu.

2. Run a transaction from the POS computer.

All commands and data sent from the POS computer will be printed as hexadecimal characters as shown in

the following illustration.

To exit the data scope mode:

1. Enter the conguration menu again.

2. Disable the data scope mode.

3. Exit the conguration menu.

The printer is once again online and can communicate normally with the POS computer.

Enabling or disabling receipt test mode

The receipt test mode veries proper receipt printing. Receipt test is enabled and disabled by selecting the

Diagnostic Modes sub-menu of the conguration menu. See Conguring the printer on page 13 for

instructions on how to enter the conguration menu.

To run the receipt test mode:

1. Enable the receipt test mode in the conguration menu.

2. Exit the conguration menu.

3. Press the paper feed button. The receipt station prints two code pages and cuts the receipt.

4. To repeat this test, press the paper feed button again.

To exit the receipt test mode:

1. Enter the conguration menu again.

2. Disable the receipt test mode.

3. Exit the conguration menu.

The printer is online and can again communicate normally with the POS computer.

Conguring the printer 15

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 44 45

Sem comentários

HP Hybrid POS Printer with MICR II Manual do Utilizador Página 21