HP Hybrid POS Printer with MICR II Manual do Utilizador descarregar pdf (Página 22)

Enabling or disabling slip test mode

The slip test mode veries proper printing on a slip. Slip test is enabled or disabled by selecting the

Diagnostic Modes sub-menu of the conguration menu. See Conguring the printer on page 13 for

instructions on how to enter the conguration menu.

To run the slip test mode:

1. Enable the slip test mode in the conguration menu.

2. Exit the conguration menu.

3. Insert a slip into the slip station.

4. Press the paper feed button. Two code pages will be printed.

5. To repeat this test, perform steps 3 and 4 again.

To exit the slip test mode:

1. Enter the conguration menu again.

2. Disable the slip test mode.

3. Exit the conguration menu.

The printer is online and can again communicate normally with the POS computer.

Enabling and disabling MICR test mode

In the MICR test mode, the check reader reads the characters on a check, but instead of transmitting the

values to the software, it prints them out. MICR test is enabled or disabled by selecting the Diagnostic Modes

sub-menu of the conguration menu. See Conguring the printer on page 13 for instructions on how to enter

the conguration menu.

To run the MICR test mode:

1. Enable the MICR test mode through the conguration menu. Then exit the conguration menu.

2. Insert a check into the slip station. (See Verifying and validating checks on page 22.)

3. After the printer detects the check, the platen closes and the characters are read by the check reader.

The decoded data is printed as characters on receipt paper. The platen then opens, and the test is

restarted.

4. The printed characters should match the characters on the check. If the check reader misreads a

character, a question mark ? is printed. If no characters can be read, NO MICR CHARACTERS is printed.

To exit the MICR test mode:

1. Enter the conguration menu again.

2. Disable the MICR test mode.

3. Exit the conguration menu.

The printer returns to normal mode and can again communicate with the POS computer.

16 Chapter 2 Setting up the printer

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 44 45

Sem comentários

HP Hybrid POS Printer with MICR II Manual do Utilizador Página 22