HP 600N Manual de Instalação descarregar pdf (Página 29)

Control Panel Configuration 3-3

Control Panel

Configuration

●

eliminate unnecessary information on the JetDirect

Configuration Page, which displays status information

for all enabled protocols.

●

display protocol-specific error conditions on the printer’s control

panel. These warning messages are displayed only if all enabled

protocols are unable to print.

To enable or disable network protocols

1. Take the printer offline by pressing [Go]. The “Ready” LED

should be off.

2. Press

[Menu] repeatedly until EIO # JETDIRECT MENU is displayed

(# identifies the EIO slot number of the card).

3. Press [Item] until CFG NETWORK=NO* appears.

NO* indicates that access to the EIO JetDirect network menus

will be bypassed. You must change this to CFG NETWORK=YES* to

access the EIO JetDirect menus:

a. Press [Value]. CFG NETWORK=YES appears.

b. Press [Select]. CFG NETWORK=YES* appears.

4. Press [Item] to scroll through each network protocol until the one

you want to change is displayed.

5. To activate the printer and save your changes, press [Go].

IPX/SPX=ON*

●

To change the protocol status, press

[Value]

and then press

[Select]

●

Press

[Item]

to continue to the next protocol.

DLC/LLC=ON*

TCP/IP=ON*

ETALK=ON*

Note:

ON* indicates the protocol is enabled.

OFF* indicates the protocol is disabled.

“ETALK” refers to the EtherTalk protocol (not available on Token Ring

cards)

S00eiohw.book Page 3 Thursday, February 24, 2000 2:26 PM

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 53 54

Comentários a estes Manuais

Sem comentários

HP 600N Manual de Instalação Página 29

Comentários a estes Manuais

Manuais e produtos relacionados com Servidores de impressão HP 600N