HP 600N Manual de Instalação descarregar pdf (Página 23)

Installing the Print Server 2-9

Installing the

Print Server

Figure 2-3 Example of HP JetDirect Configuration Page

3. If I/O CARD READY appears, the card has been installed

successfully. Proceed to “

Step 6. Configure the Card for Network

Operation

.”

4. If I/O CARD READY does not appear, check that you have:

■

Installed the card correctly and properly connected the card

to the network

■

Verified that the network is operating properly

■

Turned the printer off and then on again

Note For HP J3113A 10/100Base-TX cards: See

appendix

in this guide for special troubleshooting

information.

For LocalTalk-Only Customers: If you are

not connected to an Ethernet network, “I/O CARD

NOT READY” and “LAN ERROR - EXTERNAL

LOOPBACK” messages may appear. These

messages should stop appearing after three

minutes. To eliminate the messages, attach

an Ethernet loopback connector to one of the

Ethernet ports.

I/O CARD READY

S00eiohw.book Page 9 Thursday, February 24, 2000 2:26 PM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 53 54

Sem comentários

HP 600N Manual de Instalação Página 23