HP 600N Manual de Instalação descarregar pdf (Página 45)

HP J3113A 10/100Base-TX Print Server A-3

HP J3113A

10/100TX

Link Troubleshooting

If the HP J3113A print server does not successfully connect to the

network:

●

both link speed LEDs (10 and 100) will be off

●

a “LOSS OF CARRIER ERROR” will be indicated on the

JetDirect Configuration Page.

Note The HP J3113A 10/100Base-TX print server may

require up to 10 seconds to establish a connection

on the network.

Try the following troubleshooting procedures:

●

Verify cabling connections.

●

Use jumpers P1, P2, and P3 to manually configure the print

server. Verify that the configuration of the connecting network

device (such as a network switch) matches. For example, if you

set the print server for 100Base-TX Full-Duplex operation, the

port on the network switch must also be set to 100Base-TX

Full-Duplex operation. Be sure to power-cycle the printer.

●

On the JetDirect Configuration Page, compare your

configuration for the following parameters:

For other configuration parameters and messages on the JetDirect

Configuration Page, refer to the troubleshooting chapters in the

HP JetDirect administrator’s guide provided on the HP JetDirect

CD-ROM.

Parameter Expected Messages for 10/100TX Cards

PORT SELECT: RJ-45

PORT CONFIG: 100TX HALF, 100TX FULL,

10BASE-T HALF, 10BASE-T FULL

AUTONEG: ON (Jumper P1 set to AUTO)

OFF (Jumper P1 set for manual configuration)

S00eiohw.book Page 3 Thursday, February 24, 2000 2:26 PM

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 53 54

Sem comentários

HP 600N Manual de Instalação Página 45