HP 600N Manual de Instalação descarregar pdf (Página 44)

A-2 HP J3113A 10/100Base-TX Print Server

Link Configuration Jumper Settings

Link configuration jumpers (P1, P2, and P3) can be used to configure

the card. These jumpers should be used if the card is unable to

establish a network link through autonegotiation. If P1 is changed

to the AUTO=OFF position, then P2 selects the link speed (10 or

100 Mbps) and P3 selects the communication mode (Half duplex or

Full duplex). If you manually configure the card using jumpers P2

and P3, you must match the configuration of the connecting device,

such as the network hub or switch.

Jumper Setting Descriptions Jumper Location

(*Note: If the jumper on P1 is removed

or lost, the card defaults to the

AUTO=ON state.)

(Default)*

AUTO = ON

100 Mbps

Half-Duplex

Full-Duplex

100 Mbps

10 Mbps

Half-Duplex

10 Mbps

Full-Duplex

(AUTO = OFF)

S00eiohw.book Page 2 Thursday, February 24, 2000 2:26 PM

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 53 54

Sem comentários

HP 600N Manual de Instalação Página 44