HP Integrity NonStop H-Series Guia do Utilizador descarregar pdf (Página 296)

HP NonStop Shadowbase Command Definitions

Queue Manager Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

287

Initial Changed

Version Version Values Default Value Specifications Alter

2.000 None Valid MAT full filename No

Partial file name up to the AA prefix

–1 to reset

To know if your version of HP Shadowbase can use the parameter, the

first column titled ‘Initial Version’, is for when the parameter was first

introduced. The next column is for if and when the parameter was last

changed. If the parameter has a last changed version then the values in

the columns following, are as of that version. The next column provides

the default value. Next is provided, either the minimum to maximum

values, or the listed value specifications. The value in the last column,

titled ‘Alter’, is set to ‘Yes’ for those parameters that can be altered while

running. If the value under ‘Alter’ is ‘No’ then these parameters cannot be

altered once the Queue Manager is started.

The syntax is:

SET [ QMGR ] qmgr_parameter [ , qmgr_parameter ] ...

qmgr_parameter is one of the following:

ABNORMALSHUTDOWN {DRAINSTOP}

{DRAINPAUSE}

{STOP}

Initial Changed

Version Version Values Default Value Specifications Alter

4.092 DRAINSTOP Valid Action No

This parameter is used to control the behavior of the QMGR and its

attached Consumer in the event of AUDMON failure. When set to

DRAINSTOP, the QMGR and attached CONS drains as much of the

queue as possible and then shutdown. Any transactions still in progress

at the end of the queue are aborted. In the case of DRAINPAUSE, the

QMGR and CONS continue draining the queue and then pause until a

DRAIN command (described below) is received. In order to configure

ABNORMALSHUTDOWN to DRAINPAUSE, a TIDFILE must be

configured for the attached CONS. When set to STOP, the QMGR and its

attached CONS immediately shutdown upon detecting a failure of

AUDMON. The default value is DRAINSTOP.

BACKUPCPU num

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 345 346

Sem comentários

HP Integrity NonStop H-Series Guia do Utilizador Página 296