HP Integrity NonStop H-Series Guia do Utilizador descarregar pdf (Página 49)

HP NonStop Shadowbase Command Definitions

Monitor Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

Note: It is highly recommended that you review the Stopping HP

Shadowbase section in the HP NonStop Shadowbase Operations

Manual before issuing a SHUTDOWN command.

START AUD Command

The START AUD command starts the HP Shadowbase system. The

syntax is:

START [ AUD ] { [ COLD ] }

{ [ COOL ] }

{ [ WARM ] }

COLD

This starts the HP Shadowbase system using the configuration

information specified in the configuration input file processed by

AUDCOM. A cold start must be performed initially. Then you can use the

COOL or WARM option. A control file is created in this start mode. If one

already exists, it is purged and recreated. COLD is the default start mode.

COOL

This starts the HP Shadowbase system using the configuration

information stored in the control file from a previous COLD start. The

configured objects are only ADDed. CAPTURE, START and RUN

commands are not executed.

WARM

This starts the HP Shadowbase system using the configuration

information stored in the control file from a previous COLD start. The

configured objects are ADDed. The objects are returned to the last state

they were in before a shutdown (i.e., released, captured, suspended,

suspupd, stopped, started, and running).

STATS AUD Command

Displays statistics from the entire HP Shadowbase environment. At the

highest, it shows the adt position and last event time for all Consumers,

Queue Managers, and Collectors in the environment, or optionally, for a

single Collector and its attached Consumers and Queue Managers. Event

counts are available at the more detail level using the STATS AUD,

DETAIL command.

The syntax is:

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 345 346

Sem comentários

HP Integrity NonStop H-Series Guia do Utilizador Página 49