HP Integrity NonStop H-Series Guia do Utilizador descarregar pdf (Página 66)

HP NonStop Shadowbase Command Definitions

Collector Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

SET COLL NEXTDOCTRIGGER OFF

SET COLL PRI 99

SET COLL PROCESS \H2.$KUCL1

SET COLL PROGRAM \H2.$KGU.KGU5000E.AUDCOLLN

SET COLL PULSECLOCKADJ 0

SET COLL RESERVEDBUFFERS 10

SET COLL RESTARTFILE \H2.$KGU.CONFIGS.RSTKGU

SET COLL STATS ON

SET COLL TRACE 0

[SET COLL TRACEFILE ?]

SET COLL TURBOMODE ON

SET COLL TURBOWAITTIME 30

ADD COLL KUCL1

RESET COLL Command

The RESET COLL command resets a Collector parameter from the

currently set value to the default value. The syntax is:

RESET [ COLL ] [ coll_parameter [ , coll_parameter ] ... ]

audmon_name

Optionally specifies the Guardian process name for the HP Shadowbase

monitor process controlling the replication environment. If omitted, the

currently opened replication environment will be used.

coll_parameter options can be found if the SET COLL section.

If coll_parameter is omitted, values for all parameters are reset.

This command is typically issued between groups of SET/ADD COLL

descriptions. The command does not affect any Collector definition

already established with an ADD COLL command.

Some parameters are required and have no default values. If a required

parameter is included in the RESET COLL command, the parameter is set

to a null value; the parameter must be specified again before adding

another Collector description.

RESUME COLL Command

The RESUME COLL command places a suspended Collector into run

state. The syntax is:

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 345 346

Sem comentários

HP Integrity NonStop H-Series Guia do Utilizador Página 66