HP Integrity NonStop H-Series Guia do Utilizador descarregar pdf (Página 47)

HP NonStop Shadowbase Command Definitions

Monitor Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

Note: Tracing generates a lot of additional overhead, and will significantly

affect performance. Tracing should never be enabled except under

direction from HP Shadowbase Support.

TRACEFILE filename

Initial Changed

Version Version Values Default Value Specifications Alter

2.000 None Valid file name Include NODE Yes

When tracing is enabled, this identifies the file name where the results are

to be output. The filename can be fully qualified with volume and

subvolume names. The file can be an edit-type disk file, spooler file or the

home terminal. If writing to a disk file and you anticipate a lot of trace

output, pre-creating the disk file with larger extent sizes than the product

will create is recommended. The product creates the disk file with extents

(1 pages, 28 pages, maxextents 559). If the TRACEFILE becomes full,

HP Shadowbase will continue to run, but will not write anymore trace

output.

UNDOMODE { ON }

{ OFF }

Initial Changed

Version Version Values Default Minimum Maximum Alter

5.001 OFF OFF ON No

When set to ON, the HP Shadowbase environment is configured for

UNDO operations. UNDO operations are mutually exclusive from normal

HP Shadowbase replication, so separate environments must be

configured in order to do each. When OFF, normal replication will be

performed by the environment.

SHOW AUD Command

The SHOW AUD command displays the current values of the AUD objects

(as set by the SET AUD command) for this AUDCOM session.

SHOW [ /OUT list_file/ ] [ AUD ]

OUT list_file

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 345 346

Sem comentários

HP Integrity NonStop H-Series Guia do Utilizador Página 47