
Table 107 SSB codes that are returned by raidcom add path command (continued)
raidcom add path
DescriptionError codeExecuting/
Async
Error message
SSB2SSB1
The WWN on the side of specified external storage is not
connected to an External port.
44002E10AsyncGet Command Status
The operation cannot continue because the microcode is being
replaced.
80112E11AsyncGet Command Status
The command cannot be accepted. After a while, execute the
same command.
94002E11ExecutingCMDRJE
There is no external volume group.41002E20ExecutingCMDRJE
Invalid WWN.44002E20AsyncGet Command Status
There is no path group.45002E20ExecutingCMDRJE
/AsyncGet Command Status
The same path has been defined already.43002E22Executing/AsyncCMDRJE
Get Command Status
The operation cannot be done because the number of path in
the path group exceeds 8.
43032E23AsyncGet Command Status
The attribute of a port is not External (ELUN).84002E30ExecutingCMDRJE
The specified external storage LU is the device of not supported.40002E31AsyncGet Command Status
The specified external storage system is not supported.40012E31AsyncGet Command Status
The command cannot be accepted. After a while, execute the
same command.
00EE2EDAExecutingCMDRJE
An internal error occurred.FEEC2EDAAsyncGet Command Status
Call HP Technical Support.
An internal error occurred.FFFF2EDAAsyncGet Command Status
Call HP Technical Support.
Table 108 SSB codes that are returned by raidcom -logout command
raidcom -logout
DescriptionError codeExecuting/
Async
Error message
SSB2SSB1
Failed to release the resource lock.22002E01ExecutingCMDRJE
Table 109 SSB codes that are returned by raidcom monitor pool command
raidcom monitor pool
DescriptionError codeExecuting/
Async
Error message
SSB2SSB1
The value of pool ID is out of range.60002E00ExecutingCMDRJE
Monitor cannot be started because the performance monitor is
in the collecting status.
60042E10ExecutingCMDRJE
290 Troubleshooting
Comentários a estes Manuais