HP Web Jetadmin Software Manual do Utilizador descarregar pdf (Página 366)

1. Clearable Warnings: Control how the device tracks clearable warnings. If On is selected, a warning is

displayed until GO is pressed. If Job is selected, a warning is displayed until the end of the job in which it

was generated.

2. Show IP Address: Lets you specify whether the device IP address should be displayed along with the Ready

Message.

3. Tray Behavior:

●

Use Requested Tray: Indicates if the device will automatically try to load media from the next input

media tray in the auto-select sequence (dened by each device) when it cannot load media from the

current tray.

●

Manual feed prompt: Lets you specify whether Manual Feed Prompt will be displayed always, or only

if the tray is not loaded.

●

Size/Type prompt: Lets you specify what the control panel displays when a paper tray is opened and

closed. Congure it to display or not display the message To change size or type press check on the

control panel. In either case, HP Web Jetadmin displays a Tray empty message on the Device Status

page.

●

Use another tray: When set to Enabled, this gives the user the ability to select another tray from

which paper could be provided for the job. When set to Disabled, the user is forced to provide paper

through the same tray, after the paper mount message is posted.

4. Duplex Blank Pages: Enables or disables smart duplexing.

System Setup Ram Disk

Use this option to turn o RAM Disk functionality or to set it to automatic. If Auto, a RAM disk is created whose

size is determined by the printer as a percentage of the amount of installed memory.

To congure this option, select O or Auto.

Time Zone

Use this option to specify the Greenwich Mean Time (GMT) by selecting the time zone the device is in and specify

whether the clock for the device is automatically adjusted for daylight saving time (DST).

Use the following steps to congure this option:

1. Select the time zone for the device from the list.

2. To enable daylight saving time, select the Automatically adjust clock for daylight saving changes checkbox.

NOTE: Some time zones do not support daylight saving time. For these time zones, if the Automatically

adjust clock for daylight saving changes checkbox is selected, the Automatically Adjust for DST column in

the device lists always displays No.

-or-

To disable daylight saving time, clear the Automatically adjust clock for daylight saving changes checkbox.

340 Chapter 6 Device Conguration Options ENWW

1 2 ... 361 362 363 364 365 366 367 368 369 370 371 ... 491 492

Sem comentários

HP Web Jetadmin Software Manual do Utilizador Página 366