HP Web Jetadmin Software Manual do Utilizador descarregar pdf (Página 395)

a. Click the Add button. The Add Predened Folder wizard starts.

b. On the Choose the destination type page, select the Shared folder or FTP site option, and then click

the Next button.

c. On the Specify the shared folder settings or Specify the FTP site settings page, specify the

appropriate settings, and then click the Finish button.

3. Use the following steps to edit a predened folder:

a. Select the folder from the Predened folders list, and then click the Edit button. The Edit Predened

Folder wizard starts.

b. On the Specify the shared folder settings or Specify the FTP site settings page, change the settings,

and then click the Finish button.

4. Use the following steps to delete predened folders:

a. To delete a predened folder, select the folder from the Predened folders list, and then click the

Remove button.

-or-

To delete all of the predened folders, click the Remove All button.

b. On the Remove folders window, click the OK button.

5. To verify that the device can access the predened folder, select the folder from the Predened folders list,

and then click the Test Folder Access button. Enter the domain, user name, and password that are required

to access the folder.

NOTE: The Test Folder Access button is enabled only if you are conguring a single device because it

tests access to the network folder from that specic device.

6. In the WINS server box, enter the IP address for the WINS server.

7. From the NTLM authentication setting list, select the authentication protocol that the device uses to access

the folder.

8. From the TIFF version list, select the version of TIFF that the device uses to scan the document.

9. To verify that the device can access the predened folder before scanning begins, select the Verify access

before scanning checkbox. If the device cannot access the predened folder, the user must enter new

credentials. The job does not start until the device can access the predened folder.

-or-

To start scanning immediately after the Start button is pressed without verifying that the device can access

the predened folder, clear the Verify access before scanning checkbox. If the device cannot access the

predened folder, the job fails.

Disable predened folders

▲

Clear the Enable send to folder checkbox.

SMTP Gateway Settings

This option lets you specify the SMTP gateway settings for the digital send device. The device uses the SMTP

gateway settings to connect to an email server to send scanned documents directly from the digital send device

to an email address.

ENWW Device Conguration Options for Digital Sending 369

1 2 ... 390 391 392 393 394 395 396 397 398 399 400 ... 491 492

Sem comentários

HP Web Jetadmin Software Manual do Utilizador Página 395