HP 4400 Guia de Instalação descarregar pdf (Página 18)

2. Use a No. 2 Phillips screwdriver to remove the standard pins from the front and back of the left

and right rails (four pins on each rail).

Figure 4 Configuring the rails

3. Insert the round-hole pins into the eight holes on the rails where the standard pins were removed.

Attach the rails

NOTE:

The left and right rails are designated by the letters R (right) and L (left) stamped in the metal on the

front of the rack.

Consider the following when installing the rails:

• Installing the rails does not require any tools for assembly.

• HP recommends that you install all the rail kits before installing any other components.

• Ensure that the rails are level before installing any other components.

WARNING!

Before you begin, ensure that the rack is sufficiently stable. If provided, lower the rack leveler feet

and make sure any required stabilizers are installed. If provided, extend the anti-tip device. Failure

to extend the anti-tip device could cause personal injury or damage if the rack tips over.

Install components18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Sem comentários

HP 4400 Guia de Instalação Página 18