HP 4400 Guia de Instalação descarregar pdf (Página 26)

CAUTION:

Use appropriate precautions when handling Fibre Channel cables:

• Touching the end of a Fibre Channel cable will either damage the cable or cause performance

problems, including intermittent difficulties accessing the storage.

• Whenever a Fibre Channel cable is not connected, replace the protective covers on the ends of

the cable.

• Make certain that the Fibre Channel cables are installed and supported so that no excess weight

is placed on the connectors. This prevents damage to the connector and cable. Excess cable should

be loosely coiled and tied out of the way, being careful not to coil the cable in a tight loop. The

minimum bend radius is 25 mm for 50, 62.5, and 9 micron fiber optic cable.

Connecting device port Fibre Channel cables to the EVA (rear view)

See Figure 24 and Figure 25 in Appendix A.

Connecting Fibre Channel cables to the EVA (front end)

See Figure 26 and Figure 28 in Appendix A for front end connections with server-based management.

See Figure 27 and Figure 29 in Appendix A for front end connections with array-based management.

Connecting cables to an HSV300-S controller enclosure (front end)

See Figure 30 for server-based management or Figure 31 for array-based management in Appendix

Labeling cables using labeling kit

Label each end of each cable using the materials in the supplied labeling kit.

Connecting the power cords

WARNING!

To reduce the risk of electric shock or damage to the equipment:

• Do not disable the power cord grounding plug. The grounding plug is an important safety feature.

• Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.

• To remove power to the equipment, unplug the power cord from the power supply.

• Route the power cord so that it is not likely to be walked on or pinched by items placed against

it. Pay particular attention to the plug, electrical outlet, and the point where the cord is attached

to the EVA.

To protect your system from power failure related downtime, each EVA ships with a redundant power

supply. See Table 2 to determine the best method for connecting your power supplies to your power

source to eliminate downtime due to power-related failure.

Connect cables and power cords26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 55 56

Sem comentários

HP 4400 Guia de Instalação Página 26