HP 4400 Guia de Instalação descarregar pdf (Página 31)

Figure 15 Rear and front view of the disk enclosure

Verify the operating status of the Fibre Channel switches and

adapters

To verify that your switches are operating properly, view the switch LEDs and compare them with the

patterns described in the documentation for these devices. If the LEDs indicate a fault, see the

documentation that came with the switch for help.

Optional Step: If you will be using Fibre Channel to attach the EVA to your existing servers, you must

install Fibre Channel adapters in those servers and test the Fibre Channel adapters prior to installing

HP Command View EVA.

Ensure that you have the correct quantity and length of Fibre Channel cables available to attach your

servers to the EVA.

Installing Fibre Channel drivers

If you are using Windows, the HP SmartStart EVA Storage software automatically loads the required

Fibre Channel drivers. This occurs during this installation process when you run HP SmartStart EVA

Storage.

For other operating systems, load the drivers as directed in (Configuring application servers) in the

HP StorageWorks 4400 Enterprise Virtual Array User Guide.

Configuring the embedded switch in an HSV300-S controller

The embedded switch in an HSV300-S controller has a default IP addresses that may not be visible

in your network. Any configuration changes must be made to both embedded switches in an HSV300-S

controller enclosure. This process involves connecting a cable from the Ethernet port of each switch

to a laptop computer and supplying switch addresses that are valid for your network.

HP StorageWorks 4400 Enterprise Virtual Array Installation Guide 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Sem comentários

HP 4400 Guia de Instalação Página 31