HP 4400 Guia de Instalação descarregar pdf (Página 36)

version of HP Command View EVA on the management module, the amber indicator will flash

momentarily when the reset is completed.

Figure 18 management module

4. Temporarily connect a LAN cable from a private network to the management module. A laptop

computer works well for this.

5. From a computer on the private network, browse to https://192.168.0.1:2373 and log

in as an administrator. The user name is admin. No password is required. The WOCP GUI ap-

pears.

IMPORTANT:

The WOCP previously used port 2372 but now uses 2373.

6. Select Administrator Options > Configure Network Options.

7. Enter an IP address and other network settings that apply.

NOTE:

If you configure the management module in the 10.0.0.x network, do not use 10.0.0.1, 10.0.0.2,

or 10.0.0.3 as the IP address for the management module or any device connected to the

management module. These addresses are used by the management module.

8. Click Save Changes.

NOTE:

The IP address changes immediately, causing you to lose connectivity to the WOCP. You cannot

save changes if the EVA4400 storage system has not been initialized.

9. Remove the LAN cable connecting to the private network and reconnect the cable to the public

network.

The new IP address is stored and remains in effect even when the storage system is shut down

or restarted. However, the IP address will be lost if the storage system is uninitialized and the

WOCP is reset.

10. From a computer on the public network, browse to https://newly configured ip ad-

dress:2373 and log in as an administrator. The user name is admin. No password is required.

The WOCP GUI appears.

Connecting to the management module36

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 55 56

Sem comentários

HP 4400 Guia de Instalação Página 36