HP 4400 Guia de Instalação descarregar pdf (Página 37)

NOTE:

If the password for either the administrator or user account is changed, it should be recorded

since it cannot be cleared without performing a complete reset of the WOCP.

Connecting through a private network

Use this procedure when the management module will not be connected through a public network or

the array has not yet been initialized.

1. Press and hold the recessed Reset button (2, Figure 18) for 4 to 5 seconds. This sets an IP address

of 192.168.0.1. If you are running HP Command View EVA 9.3 or later on the management

module, the amber indicator on the top right corner of the Ethernet port (1, Figure 18) will flash

momentarily when the reset starts. When the reset is complete (approximately two minutes), the

green indicator on the top left corner of the Ethernet port stays on. If you are running an earlier

version of HP Command View EVA on the management module, the amber indicator will flash

momentarily when the reset is completed.

2. Browse to https://192.168.0.1:2373 and log in as an administrator. The user name is

admin. No password is required. The WOCP GUI appears.

3. If network setting changes are required, select Administrator Options > Configure Network Options.

Enter an IP address and other network settings that apply.

NOTE:

If you configure the management module in the 10.0.0.x network, do not use 10.0.0.1, 10.0.0.2,

or 10.0.0.3 as the IP address for the management module or any device connected to the

management module. These addresses are used by the management module.

4. Click Save Changes.

NOTE:

The IP address changes immediately, causing you to lose connectivity to the WOCP. You cannot

save changes if the EVA4400 storage system has not been initialized.

The new IP address is stored and remains in effect, even when the storage system is shut down

or restarted. However, the IP address will be lost if the storage system is uninitialized and the

WOCP reset.

5. From a computer on the private network, browse to https://newly configured ip ad-

dress:2373 and log in as an administrator. The user name is admin. No password is required.

The WOCP GUI appears.

Accessing HP Command View EVA on the management module

To access HP Command View EVA on the management module complete the following:

1. Click Launch Command View EVA.

HP StorageWorks 4400 Enterprise Virtual Array Installation Guide 37

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Sem comentários

HP 4400 Guia de Instalação Página 37