
System Error Codes
2-14
HP DesignJets 500, 510 and 800 Series Printers Service Manual
System Error: 61:05
Problem
Description:
Error Processing Job. This Error Code only appears in HP DesignJets
800 Series, or in the HP DesignJet 500 and 510 Series
with
an HP-
GL/2 card installed, when processing either a PostScript or HP-GL/2
file.
Corrective Action: Try the following:
Switch the Printer Off and wait a few minutes. Switch the Printer
On again and resend the file that you were trying to print.
If the Error Code reappears after resending the file, then try
generating the file again and try to print again.
If the file that is causing this error is PostScript, check if it is
Binary. If the file is Binary, use AppleTalk to send the file to the
Printer. If AppleTalk is not being used to send the Binary file to
the Printer, then change the PostScript settings to Binary through
the Front Panel (Set-up menu / PS settings / Encoding / Binary).
If the Error Code continues to reappear, check for a new release
of the Driver.
System Error: 64:04
Problem
Description:
Firmware Error (USB Port).
Corrective Action: Try the following:
Switch the Printer Off and wait a few minutes. Switch the Printer
On again and check if the Error Code has disappeared.
If the Error Code reappears, check for a new Firmware release.
If the new Firmware release does not solve the problem, or if new
Firmware release was not available, then contact the HP
Response Center (or directly to the Division) supplying the
following information:
– Model and Serial Number of the Printer.
– Firmware release of the Printer (use the Printer Information
utility
⇒
Page
4-27
).
– The complete Error Code information, including the linefeed
where the error occurred (use the Error Log utility to obtain this
information
⇒
Page
2-5
).
Comentários a estes Manuais