HP CH336A#B1K Manual do Utilizador descarregar pdf (Página 91)

Service Tests and Utilities

4-21

HP DesignJets 500, 510 and 800 Series Printers Service Manual

If you want to Reset the EEROM to the Default Values

NOTE The EEROM should only be reset if there is a major problem or

if the Electronics Module has been replaced by a reused one and

you need to reset the EEROM configuration. Also reset the

EEROM if the Printer does not have the correct Serial Number

after powering up.

a If you want to reset the EEROM to the default values, then you

should select "Reset to defaults" and press Enter. The following

message will appear on the Front Panel. Press Enter if you want

to proceed with resetting the EEROM or press Cancel if you

want to exit without resetting the EEROM:

NOTE After resetting the EEROM to the default values, you will need to

re-enter the Serial Number, Model Number and the Font Type

(without re-entering this information, the Printer will NOT work).

DO NOT SWITCH THE PRINTER OFF AND ON AGAIN

BEFORE RE-ENTERING THESE VALUES. Also you will need

to perform the Factory Advance Calibration.

Reset to defaults

Press ENTER to continue

or CANCEL to quit

Back

Enter

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 284 285

Sem comentários

HP CH336A#B1K Manual do Utilizador Página 91