Hp Library and Tape Tools Manual do Utilizador descarregar pdf (Página 105)

• Write 1GB of data for DAT72 and below and 2GB of data for DAT160 and above and then

measures the write margin.

• Read 1GB of data for DAT72 and below and 2GB of data for DAT160 and above and then

measures the read margin.

1/8 Autoloader Assessment tests performed:

• Review robotics error log entries.

• Run appropriate drive assessment test on the drive.

• Check for new robotics error log entries.

• Perform 12 to 24 drive loads and unloads (depending on drive type)

• Check for new robotics error log entries.

Options

Enable Passive Test (defaults to TRUE)—Analyzes drive history (runs device

analysis and looks at DDS Reports information).

•

• Allow overwrite(defaults to FALSE)—Set to TRUE to avoid the pop-up warning

about erasing data on the tape.

• Ignore Cleaning Requests (defaults to FALSE) —When TRUE the test will

not check whether the drive is requesting cleaning

• Amount of Media to Test (defaults to 1GB for DAT72 and below and 2GB for

DAT160 and above)—Select the entire tape to test all of the tape.

• Number of Iteration (default is one) – Number of times to run the write portion

of the test.

DLT, DLT1, VS80, VS160, and SDLT Assessment tests performed:

• SCSI interconnect test

• Review event log entries (that were present prior to running this test)

• Load the test tape

• Quick write/read test

• Soft unload/load test (DLT assessment test only)

• Minimum block size test

• Diagnostic Self-test (built-in drive function)

• Read/write tests, using various data patterns

• Bit error rate test

• Review new event log entries added during the test

• Unload the test tape

Performance tests 105

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 181 182

Sem comentários

Hp Library and Tape Tools Manual do Utilizador Página 105