Hp Library and Tape Tools Manual do Utilizador descarregar pdf (Página 82)

• Drive Test Option—If the Drive Load test is enabled, specify one of the following options:

Off◦

◦ Data loop back (default)

◦ Read-only

◦ Read/write

• Cartridge Load Test—Specify one of the following options for the Cartridge Load test:

Off (default)◦

◦ Single drive

◦ Multiple drives

◦ All drives

• CM Integrity Mode—Specify whether to enable the CM integrity check option for LTO

drives. The default setting is on.

Library Read Write test

Table 11 Library Read Write test details

Library Read Write testDetails/Library specific test

The Library Read Write test automates the testing of the drives and tapes in a tape

library. This test assumes that the library robotics are working properly. To test the

library robotics, use “Library Exerciser test” (page 79) or “Move test” (page 90).

Description

For instructions on how to perform this test, “Running tests and device-specific utilities”

(page 29) or “Running the tests (CSI)” (page 50).

Run this test to verify that the tapes and drives are functioning properly.When to run

Highly dependent on the library being tested and the options selected.Duration

82 Tests

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 181 182

Sem comentários

Hp Library and Tape Tools Manual do Utilizador Página 82