Hp Library and Tape Tools Manual do Utilizador Página 85

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 84
Table 11 Library Read Write test details (continued)
Library Read Write testDetails/Library specific test
configuration of tape locations. If the Library Read Write test is run after a tape is
removed from the library, the information about that tape is discarded from the log
file.
TIP: To keep log information about a tape that has been discarded from the library,
copy or rename the log file before running the Library Read Write test.
The test determines which tapes to use based on the test option settings for Starting
slot, Number of test tapes, Drive type, Ignore barcode labels,
and whether or not the tapes will be written (see Allow overwrite). For example,
LTO-1 tapes will not be included in an LTO-3 drive test where tapes are written because
LTO-1 tape is not write-compatible with LTO-3 drives.
The test determines which drives to use based on the test option settings for Drive
type and Drive range.
The other test options determine the testing sequence for the selected tapes and drives.
This testing sequence is always the same for each of the selected drives and tapes.
This test can be stopped before it completes. To abort the test from the GUI, click Abort
Test. To abort the test from the CSI, use the Ctrl-A key combination.
Slot and drive numbering is one-based (the first slot is 1), which is consistent with L&TT.
Some supported libraries use zero-based numbering on the library front panel. In this
case, the test numbering will be off by one from the front panel.
DDS autoloadersAvailable for
ESL Vendor ID test
Table 12 ESL Vendor ID test details
ESL Vendor ID testDetails/Library specific test
Toggles the Vendor ID in an ESL library between HP and Compaq.Description
NOTE: For instructions on how to perform this test, see “Running tests and
device-specific utilities” (page 29) or “Running the tests (CSI)” (page 50). The test
requires firmware version 3.40 or later.
Run this test to change the vendor ID, which may be required for some applications
to work properly.
When to run
< 1 minuteDuration
ESL librariesAvailable for
Other tests
“Installation Check test” (page 86)
“Connectivity test” (page 86)
“LTO Cooling Check test” (page 87)
“Data Compression test” (page 87)
“LTO Encryption test” (page 88)
“Device Configuration test” (page 88)
“Device Self-test” (page 89)
“Move test” (page 90)
“Read/Write Stress test” (page 90)
“Full Sweep test” (page 91)
Diagnostic tests 85
Vista de página 84
1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 181 182

Comentários a estes Manuais

Sem comentários