HP 2000CP 2500CP Manual do Utilizador descarregar pdf (Página 124)

Service Calibrations

5-3

HP DesignJet CP Series Printers

Service Calibrations

The following is a list of all internal service calibrations available in the

Printers. Instructions for entering the service calibrations menu are given

on page 5-5.

WARNING

ALL THE COVER SENSORS ARE DISABLED WHEN IN THE

CALIBRATIONS MENU. IF THE CARRIAGE IS MOVING IT WILL

NOT STOP IF THE WINDOW IS OPENED, SO BE VERY CAREFUL

NOT TO PUT YOUR HANDS INSIDE.

1 Carriage  page 5-7

The purpose of this calibration is to calibrate the temperature from

which the printhead has to be warmed.

2 Refill  page 5-9

The purpose of this calibration is to ensure the correct position of the

carriage assembly in respect to the refill assembly.

3 Line Sensor  page 5-10

The purpose of this calibration is to calibrate the intensity of the line

sensor in the carriage PCA. An incorrect calibration can result in

edge-detection failures during media loading and incorrect reading of

prints that are used for alignment or calibration.

4 Service Station  page 5-12

This Calibration is no longer required and should never be performed.

5 Printheads Alignment  page 5-13

The purpose of this calibration is to test and if necessary correct the

misalignment between the printheads. This Calibration is necessary to

avoid color misalignments and print quality defects like banding.

6 Printheads Check  page 5-14

The purpose of this calibration is to check that the Nozzles of the

Printheads are functioning correctly.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 347 348

Sem comentários

HP 2000CP 2500CP Manual do Utilizador Página 124