HP 2000CP 2500CP Manual do Utilizador descarregar pdf (Página 283)

8-62 Removal and Installation

HP DesignJet CP Series Printers

Bail Stepper Motor

Refer to figure 22  page 8-63

Removal



Switch off the printer and remove the power cord.

1. Remove the following:

1. Left Hand Cover  page 8-18.

2. Bail Arm Assembly  page 8-58

2. Remove the top half of the elevator assembly by releasing it from two

retaining clips at the back and lifting up and to the left.

3. Disconnect the bail stepper motor cable (item 1) from position J7

STEPPER MOTOR on the refill interconnect PCA (item 2).

4. Release the bail stepper motor cable from the cable clamp (item 3) on the

left hand side chassis.

5. Remove the bail stepper motor (item 5) by removing two T-10 screws

(item 4).

Installation

1. Install the bail stepper motor (item 5) in the correct position on the left

hand side chassis.

2. Install two T-10 screws (item 4) into the left hand side chassis securing

the bail stepper motor.

3. Connect the bail stepper motor cable (item 1) to the refill interconnect

PCA (item 2) in position J7 STEPPER MOTOR.

4. Install the bail stepper motor cables into a cable clamp (item 3) on the

left hand side chassis.

5. Install the top half of the elevator assembly by securing it to two

retaining clips at the back and push down and to the right.

6. Install the following:

1. Left Hand Cover  page 8-18.

2. Bail Arm Assembly  page 8-58

7. Connect the power cord and turn the printer on in service mode.

8. Perform D11 Bail Service Test  page 4-25

1 2 ... 278 279 280 281 282 283 284 285 286 287 288 ... 347 348

Sem comentários

HP 2000CP 2500CP Manual do Utilizador Página 283