HP 2000CP 2500CP Manual do Utilizador descarregar pdf (Página 236)

8-15 Removal and InstallationHP DesignJet CP Series Printers

Window and Top Cover

Refer to figures 3 and 4  page 8-16 and 8-17

Removal



Switch off the printer and remove the power cord.

1. Remove two T-15 screws (item 1 on figures 3 & 4) securing the top cover

to the left and right hand covers.

2. Loosen the screws (item 2 on figure 3) on the left hand cover.

3. Pulling the left hand cover aside remove the window (item 3 on figure 4).

4. Remove the rear left and right hand back covers.

5. Remove five T-20 screws from the rear of the top cover.

6. Remove the top cover (item 4 on figure 3).

Installation

1. Install the top cover (item 4 on figure 3) making sure that the two small

wire clamps on the centronics port are positioned vertically.

2. Install the five T-20 screws into the rear of the top cover.

3. Install the rear left and right hand back covers.

4. Carefully push the left hand cover aside and install the window

(item 3 on figure 4).

5. Tighten the screws on the left hand cover (item 2 on figure 3).

6. Using two T-15 screws, secure the rear cover to the left and right hand

covers (item 1 on figures 3 & 4).

7. Connect the power cord and turn the printer on in service mode.

8. Perform D08 Sensors Service Test  page 4-20

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 347 348

Sem comentários

HP 2000CP 2500CP Manual do Utilizador Página 236