HP 2000CP 2500CP Manual do Utilizador descarregar pdf (Página 271)

100

101

8-50 Removal and Installation

HP DesignJet CP Series Printers

Cutter Assembly (Only Applicable to

HP DesignJets 3500CP and 3000CP)

Refer to figure 17B  page 8-51

Removal



Switch off the printer and remove the power cord.

1. Remove the following:

1. Right Hand Cover  page 8-21.

2. Move the Carriage Assembly to the right.

3. Loosen the screw (item 1) located on the right end of the Starguard.

4. Remove the cutter assembly (item 2) from the slider rod by sliding it to

the right and pulling it off the rear bushing (item 3).

Installation

Note: Make sure that when you install the Cutter Assembly that

both black wheels of the cutter assembly enter the starguard

assembly.

1. Install the cutter assembly (item 2) onto the rear bushing (item 3) and

slide to the left. To obtain the correct position so that the cutter assembly

moves easily into position, you may have to move the cutter wheel

(which is sprung loaded).

2. Tighten the screw (item 1) located on the right end of the Starguard

assembly onto the overdrive assembly.

3. Install the following:

2. Right Hand Cover  page 8-21.

4. Install the power cable and turn the printer on in service mode.

5. Perform D10 Cutter Service Test  page 4-24

1 2 ... 266 267 268 269 270 271 272 273 274 275 276 ... 347 348

Comentários a estes Manuais

Sem comentários

HP 2000CP 2500CP Manual do Utilizador Página 271

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir HP 2000CP 2500CP