HP 2000CP 2500CP Manual do Utilizador descarregar pdf (Página 305)

8-84 Removal and Installation

HP DesignJet CP Series Printers

Pincharm Assemblies, Pincharm Shaft and

Pincharm Sensor

Refer to figure 28  page 8-86

Removal of the pincharm sensor



Switch off the printer and remove the power cord.

1. Remove the following:

1. Right Hand Cover  page 8-21.

2. Service Station Assembly  page 8-26

2. Remove the two T-10 screws (item 1) securing the pincharm sensor to the

right hand side chassis.

3. Remove the pincharm sensor cable from the cable clamp (item 2) secured

to the left hand side chassis.

4. Disconnect the pincharm sensor cable from the electronics module in

position J8 PINCH.

Removal of the pincharm assemblies and the pincharm shaft.

1. Remove the following:

1. Window and Top Cover  page 8-15.

2. Left Hand Cover  page 8-18.

3. Right Hand Cover  page 8-21.

4. Service Station Assembly  page 8-26.

5. Overdrive assembly and Drive roller  page 8-69.

2. To remove the pincharm shaft (item 6), loosen the T-9 screw (item 3) at

the right end of the pincharm shaft. Be careful not to loosen the screw

too much as you may loose the nut (item 5)

3. Remove the top half of the elevator assembly by releasing it from two

retaining clips at the back and lifting up and to the left.

4. Pull out the cam journal (item 4) from the hole in the right hand side

chassis

5. Remove the pincharm shaft from the left side of the printer by pulling it

out.

6. To remove any of the pincharm assemblies (item 7) pull out from the

chassis.

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 347 348

Sem comentários

HP 2000CP 2500CP Manual do Utilizador Página 305