HP 2000CP 2500CP Manual do Utilizador descarregar pdf (Página 295)

8-74 Removal and Installation

HP DesignJet CP Series Printers

7. Install the top half of the elevator assembly by securing it to two

retaining clips at the back and push down and to the right.

8. Install the following:

1. Cutter Assembly  page 8-50

2. Bail Arm Assembly  page 8-58

IF YOU ARE INSTALLING A NEW OVERDRIVE ASSEMBLY,

YOU MUST INSTALL THE OVERDRIVE SHIMS IN ORDER TO

PREVENT THE CUTTER ASSEMBLY FROM CRASHING INTO

THE BAIL ASSEMBLY.

9. You must install the Overdrive Shims on the Overdrive Assembly as

follows (Refer to Figures 25D and 25E on page  8-77):

1. Peel the paper from the back of the first Overdrive Shim (Item 1) and

install it on the Linear Blade (Item 2) of the Overdrive Assembly on the

left-hand side of the Printer (Refer to Figure 25D).

Make sure that when you install the Overdrive Shim (item 1)

that there is a gap of approximately 3mm between the Overdrive

Shim (Item 1) and the Cutter Assembly Shim (Item 3) as shown

on Figure 25D.

2. Peel the paper from the back of the second Overdrive Shim (Item 1)

and install it on the Linear Blade (Item 2) of the Overdrive Assembly

on the right-hand side of the Printer (Refer to Figure 25E).

Make sure that when you install the Overdrive Shim (item 1)

that there is a gap of approximately 3mm between the Overdrive

Shim (Item 1) and the Cutter Assembly Shim (Item 3) as shown

on Figure 25E.

10.Install the following:

1. Right Hand Cover  page 8-21.

2. Left Hand Cover  page 8-18.

3. Window and Top Cover  page 8-15.

11.Connect the power cord and turn the printer on in service mode.

12.Perform following calibrations:

1. C08 Service Accuracy Calibration  page 5-17.

13.Perform following service tests:

1. D11 Bail Service Test  page 5-12

2. D05 Service Station Service Test  page 4-16

1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 347 348

Sem comentários

HP 2000CP 2500CP Manual do Utilizador Página 295