HP 2000CP 2500CP Manual do Utilizador descarregar pdf (Página 274)

100

101

Removal and Installation

8-53

HP DesignJet CP Series Printers

Installation

Note: At the same time as performing step one, install loose

cables into the cable clamp, which is located on the left hand

side chassis.

1. Install the elevator assembly onto the three loosened T-20 screws (item

2). Tighten the three screws.

2. Install the T-20 screw (item 1) into the bottom rear of the elevator

assembly.

3. Connect the platform sensor cable in position J5 PLATEF SENSOR on

the refill interconnect PCA.

4. Connect the elevator stepper motor cable in position J9 ELEV

STEPPER on the refill interconnect PCA.

5. Install the top half of the elevator assembly by securing it to two

retaining clips at the back and push down and to the right.

6. Install the following:

1. Left Hand Cover  page 8-18.

2. Window and Top Cover  page 8-15.

7. Install the ink delivery system (Refer to the User Guide).

8. Install the power cable and turn the printer on in service mode.

9. Perform D06 Refill Service Test  page 4-18

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 347 348

Comentários a estes Manuais

Sem comentários

HP 2000CP 2500CP Manual do Utilizador Página 274

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir HP 2000CP 2500CP