HP Apollo 9000 400t Manual de Serviço descarregar pdf (Página 146)

4-76 Fault Isolation

10. To ﬁnd out what ce.utilities tests are already in the HP-UX operating system,

type these commands:

cd /usr/diag/CE.utilities < Return >

ls < Return >

11. If you want to run a test that is not already in HP-UX, you must ﬁrst copy the test

from the tape to the HP-UX ﬁle system. A new directory, /usr/CE.utilities, is

automatically created and the ﬁles from the tape are copied into it. Type the fol-

lowing command, where test is one of the eight test ﬁles you want to copy from the

tape to the ﬁle system:

lifcp -r /dev/drive:test - | cpio -icdvxm < Return >

Information on each CE.utility test may be found as follows:

• CRTADJ: refer to System Support Tape User’s Guide

• CS/80: refer to the Series 300 Test Tools Manual

NOTICE: If the CS/80 test is run in single user mode, the sys

tem halts when the exerciser is stopped. You must

reboot HP-UX to continue.

• FLOAT type the following commands and a help ﬁle appears on the screen.

cd /usr/CE.utilities/Floatcard < Return >

./help < Return >

• SFT refer to the Series 300 Test Tools Manual

• VME: type the following command and a readme ﬁle appears on the screen.

more vme_README < Return >

• ECC: type the following commands for information on setting up and execu-

ting the ECC tests.

cd /etc

man ecclogger < Return >

Refer to the System Support Tape User’s Guide and the Series 300 Test Tools Manual

for detailed information on running the CE.utilities.

end of procedure

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 295 296

Sem comentários

HP Apollo 9000 400t Manual de Serviço Página 146