HP Apollo 9000 400t Manual de Serviço descarregar pdf (Página 182)

5-34 FRU Removal and Replacement

5.5.8 Bezel Replacement (Model 400s)

The bezel is usually not removed for servicing Model 400s system units. If a bezel is

damaged, it may be removed by referring to Figure 5-27 and following these steps.

However, the catches often break in the process, so you probably cannot reinstall the

original bezel.

1. Insert a small, ﬂat-tipped screwdriver into the bezel’s left, top catch access hole

and push the catch up, then pull out on the bezel’s left top side.

2. Insert a small, ﬂat-tipped screwdriver into the bezel’s left, bottom catch access

hole and push the catch down, then pull out on the bezel’s left bottom side.

3. Insert a small, ﬂat-tipped screwdriver into the bezel’s right, top catch access

hole and push the catch up, then pull out on the bezel’s right top side.

4. Insert a small, ﬂat-tipped screwdriver into the bezel’s right, bottom catch access

hole and push the catch down, then pull out on the bezel’s right bottom side.

5. Grasping the bezel’s top, right and left sides, pull the bezel off the system unit.

To replace the bezel, follow these steps:

1. Position the bezel on the system unit with its top away from the system unit.

Align its two lower catches with their respective holes in the chassis.

2. Rotate the top of the bezel into place, ﬁtting the power switch hole over the

power switch pushbutton and the two left catches into place.

3. Push the bezel in and snap it into place. Make sure that the bezel ﬁts correctly

into all the chassis parts.

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 295 296

Sem comentários

HP Apollo 9000 400t Manual de Serviço Página 182