
5-50 FRU Removal and Replacement
5.5.18 HP-IB Interface Board Removal and Replacement (Model 400s)
Refer to Figure 5-37 and follow these steps to remove the HP-IB interface board. Re
-
verse these steps to replace the HP-IB interface board.
1. Remove the HP-IB plate.
2. Disconnect the ribbon cable from the HP-IB interface board.
3. Remove the HP-IB interface connector screws from the HP-IB plate.
4. Remove the HP-IB interface board from the HP-IB plate. To replace the HP-IB
board, reverse the removal procedures.
NOTICE: When replacing the HP-IB interface board, you must insert it
into the HP-IB plate with its component side towards the right
side of the system unit.
Figure 5-37. Model 400s HP-IB Board Removal
Comentários a estes Manuais