HP Apollo 9000 400t Manual de Serviço Página 210
- Página / 296
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
5-62 FRU Removal and Replacement
5.5.26 Standard/ISA Motherboard Removal and Replacement (Model 400s)
Refer to Figure 5-44 and follow these steps to remove the motherboard.
1. Remove the top and side covers, CPU board with plate, all DIO boards, RFI
cover, all ISA cards and backplane, card cage, center wall, and right trim plate.
2. Disconnect the following cable connectors from the component side of the
motherboard:
• Main power distribution cable connector. Use a flat-tipped screwdriver to
press in on each side clip. Then, pull the connector out.
• Power switch cable connector.
• Main fans cable connector.
3. Remove the eight screws from the mass storage cover plate on the left side of
the chassis. Remove the mass storage cover plate.
4. Remove the lower mass storage mounting screws from the right side of the
chassis. Pull the mass storage device out four inches.
5. Disconnect the mass storage power distribution and SCSI cable from the back
side of the motherboard.
6. Remove the four screws holding the motherboard to the chassis.
7. Remove the motherboard by sliding it to the right so that its mounting pins
clear their holes. Then, pull it out.
Follow these steps to replace the standard/ISA motherboard:
1. Position the motherboard by placing it on its mounting pins. Then, slide it to
the left so that its tabs fit into their slots in the chassis.
2. Install the four motherboard screws to hold the motherboard to the chassis.
3. Connect the mass storage power distribution and SCSI cable to their connectors
on the back side of the motherboard.
4. Reinstall the lower mass storage device, if necessary.
5. Reinstall the mass storage cover plate.
6. Reconnect all cable connectors to the component side of the motherboard.
7. Replace the remaining assemblies.
- Series 400 Workstations 1
- Emissions Regulations 3
- VCCI Class 1 ITE Equipment 4
- VCCI Class 2 ITE Equipment 4
- Preface 7
- Audience 8
- Domain/OS Related Manuals 8
- HP-UX Related Manuals 9
- Documentation Conventions 10
- Contents 11
- Contents xiii 13
- Domain/OS Systems 15
- Contents xvii 17
- Contents xix 19
- Procedures 21
- Chapter 1 23
- 1.1 Introduction 24
- 1-4 Product Overview 26
- 1.2 Physical Configuration 27
- 1-8 Product Overview 30
- 1.5 Introduction 31
- 1.6 Physical Configuration 33
- 1-16 Product Overview 38
- Chapter 2 41
- 2-2 System Controls 42
- System Controls 2-3 43
- 2.2 Monitor Controls 46
- System Controls 2-7 47
- 2-8 System Controls 48
- 2.3 LED Indicator Lights 49
- Chapter 3 51
- 3-4 Theory of Operation 54
- Theory of Operation 3-5 55
- 3-6 Theory of Operation 56
- Theory of Operation 3-7 57
- 3-8 Theory of Operation 58
- 3.2 FRU-Level Operation 59
- Uncorrectable Memory Error 65
- 3-20 Theory of Operation 70
- Chapter 4 71
- Compatible Mode 73
- 4-4 Fault Isolation 74
- Figure 4-1. Main Flowchart 74
- Fault Isolation 4-5 75
- 4-6 Fault Isolation 76
- Fault Isolation 4-7 77
- 4-8 Fault Isolation 78
- Fault Isolation 4-9 79
- 4-10 Fault Isolation 80
- Fault Isolation 4-11 81
- 4-12 Fault Isolation 82
- Fault Isolation 4-13 83
- 4-16 Fault Isolation 86
- 4.3 Mnemonic Debugger Level 87
- 4-22 Fault Isolation 92
- 4.4 The sysboot Program 95
- 4.5 Online Level 96
- Fault Isolation 4-29 99
- 4-30 Fault Isolation 100
- Fault Isolation 4-31 101
- 4.9 Boot ROM Self-Tests 108
- Fault Isolation 4-43 113
- Fault Isolation 4-45 115
- Fault Isolation 4-47 117
- Fault Isolation 4-49 119
- 4.10 Test Mode 122
- CONTINUE AT OWN RISK 123
- RETURN To Continue 123
- Memory Failed at (address) 124
- (W:BBCCDDEE, R:BBCCDDEF) 124
- PARITY BIT ERROR AT (address) 124
- 4-56 Fault Isolation 126
- Fault Isolation 4-57 127
- Part 3 Checkout Procedures 130
- Fault Isolation 4-61 131
- 4-62 Fault Isolation 132
- Fault Isolation 4-67 137
- J001 14 137
- Domain Compatible Mode 139
- Compatible Mode 147
- Chapter 5 149
- 5.3 System Assemblies 150
- 5.5 System Unit Assemblies 172
- (Continued) 227
- Appendix A 235
- A-2 FRU Confi gurations 236
- A-6 FRU Confi gurations 240
- FRU Confi gurations A-7 241
- FRU Confi gurations A-11 245
- Hard Disk Drive 245
- A-12 FRU Confi gurations 246
- Tape Drive 246
- FRU Confi gurations A-13 247
- A-14 FRU Confi gurations 248
- Appendix B 249
- Appendix C 253
- C-2 Confi guring the EEPROM 254
- C.4 I/O Configuration Mode 264
- Configure Mode Failed 265
- Configuration EEPROM Failed 265
- 1 Select Code 9 268
- used select codes are : 268
- 12 14 15 21 268
- C.5 Auto System Select Mode 277
- Appendix D 283
Manuais e produtos relacionados com Barebones PC/estação de trabalho HP Apollo 9000 400t
(24 páginas)
Barebones PC/estação de trabalho HP 8200 - Elite Convertible Minitower PC Especificações Rápidas
(73 páginas)
(73 páginas)
Barebones PC/estação de trabalho HP Dc5850 - Compaq Business Desktop Especificações Rápidas
(54 páginas)
(54 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.036 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais