HP 220mx Guia do Utilizador Página 336
- Página / 378
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Autochanger Error Codes
Jukebox Micro-Move Error Codes
Appendix B B-49
Autochanger Error Codes
34 SCSI Interface
Controller Chip Test
Checks out operations of the SCSI interface
controller chip. This test will not be run if
initiated via SCSI, it reports PASS.
36
Motor Control Chip
Test
Exercises the registers of the motor control IC.
In order to perform correctly, this test shuts
down the servo system.
37
Drive Connect Test Checks for expected drive configuration. This is
done by polling the drive connect signal on each
of the possible drives. This line is grounded at
the drive end if a drive is connected. If the drives
physically connected do not match the expected
configuration then an error is reported.
38
Control Panel Light
Show &Button Test
Lights each portion of the display individually
and then together. Requires pushing each front
panel button to finish the test.
40
Power Supply Test Looks at both the 12-Volt and the 24-Volt power
supplies to verify that they are within limits.
The limits for the 12V supply are 11V and 13V
and the 24V supply limits are 23.5V and 25.5V.
41
SCSI Connector
Loopback Test
(Interactive)
Performs a loopback through SCSI connectors,
checking proper operation of the SCSI drivers,
receivers, and cables. Requires an external
loopback hood with terminator power. Will not
run if it was initiated via SCSI; if so, it reports
error FCH Test Did Not Run.
42
Optical Sensor Test
(Interactive if done
through the control
panel)
Checks the status of the optical sensors. Also
checks the status of the mailslot sensor (see Test
43). "0"s are placed on the control panel display
on the left and right of the display. The mark is
an open zero if the sensor is not blocked, and a
zero filled in with lit segments if a sensor is
blocked. No FRU is returned.
Table B-13 Sequence Tests (For models 40fx, 80ex, 125ex, and 220mx ONLY)
No. Test Name Description
- Command Reference 2
- Revision History 3
- Typographical Conventions 4
- In This Manual 5
- Contents 10
- 1 SCSI Command Overview 20
- Drive Control Commands 22
- Good 00H 33
- Check Condition 02H 33
- Condition Met 04H 33
- Busy 08H 34
- Intermediate/Good 10H 34
- Reservation Conflict 18H 34
- Queue Full 28H 34
- Conditions 35
- 2 SCSI-2 Drive Command Set 38
- Flag, Link, and RelAdr 44
- Test Unit Ready Command (00H) 45
- Sense Data Format 48
- Field Pointer Types 50
- Format Unit Command (04H) 52
- Reassign Blocks Command (07H) 56
- Read (Group 0) Command (08H) 58
- Write (Group 0) Command (0AH) 60
- Seek (Group 0) Command (0BH) 62
- Mode Select Command (15H) 68
- Mode Select Header 70
- Read-Write Error Recovery 71
- Disconnect-Reconnect 73
- Caching Page 08H 74
- Control Mode Page 0AH 76
- Vendor Unique Format Page 20H 79
- Format Mode 03H 80
- Vendor Unique Page 21H 83
- DIP Switch Locations 88
- Read-Write Error Recover Page 94
- Disconnect-Reconnect Page 02H 96
- Control Mode Page (0AH) 100
- Medium Types 101
- SCSI-2 Drive Commands 102
- Vendor Unique 103
- Format Mode 104
- Read Capacity Command (25H) 117
- Read (Group 1) Command (28H) 119
- Seek (Group 1) Command (2BH) 124
- Pre-Fetch (34H) 131
- Synchronize Cache (35H) 132
- Write Buffer Command (3BH) 136
- Read Buffer Command (3CH) 139
- Read Long Command (3EH) 141
- Write Long Command (3FH) 143
- Log Select Command (4CH) 146
- Parameter List Data 147
- Log Sense Command (4DH) 148
- Supported Log Pages 00H 149
- Read (Group 5) Command (A8H) 165
- Read Long Command (DEH) 182
- Write Long Command (DFH) 184
- SCSI-2 Drive Command Set 187
- Chapter 22-150 187
- 3 Jukebox SCSI-2 Command Set 188
- Numerical List of Commands 189
- Alphabetical List of Commands 191
- Rezero Unit Command (01H) 194
- Request Sense Command (03H) 195
- Rotate Mailslot Command (0CH) 200
- Inquiry Command (12H) 201
- Inquiry Command Data 202
- Vital Product Data Pages 203
- Reserve Command (16H) 205
- Release Command (17H) 207
- Mode Sense Command (1AH) 208
- Transport Element (Picker) 212
- Device Capabilities 213
- Send Diagnostic Command Data 223
- Error Logs Table Format 236
- Move Success Log Table Format 240
- Force Log Data Format 241
- Recovery Log Data Format 242
- Drive Log Data Format 244
- Odometer Log Data Format 245
- Run-Time Log Data Format 246
- Retry Log Data Format 248
- Move History Log Data Format 250
- Move Medium Command (A5H) 251
- Read Element Status Data 256
- A Drive Error Codes 264
- Chapter Overview 265
- Drive Error Codes 266
- Internal Error Codes 272
- DSP Error Codes 282
- Drive Error Codes 287
- Appendix AA-24 287
- B Autochanger Error Codes 288
- Request Sense Error Codes 290
- Autochanger Error Codes 292
- Recovery 295
- Hardware Error Codes 306
- Autochanger Move Error Codes 316
- Diagnostic Tests 327
- Initialize Element 332
- Autochanger Error Codes 339
- Appendix BB-52 339
- Appendix C C-1 340
- Field Replaceable Units 342
- Appendix CC-6 345
- D Micro/Macro-Moves 346
- Micro/Macro-Moves 348
- Micro/Macro-Moves 369
- Appendix DD-24 369
- E Disconnect Timeout Settings 370
- Disconnect Timeout Settings 371
- Disconnect Timeouts 372
- Appendix EE-4 373
Manuais e produtos relacionados com Discos rígidos internos HP 220mx
Discos rígidos internos HP J9F51A Ficha Técnica
(44 páginas)
(44 páginas)
Discos rígidos internos HP QK555AT Ficha Técnica
(8 páginas)
(8 páginas)
Discos rígidos internos HP C8R65A Ficha Técnica
(38 páginas)
(38 páginas)
Discos rígidos internos HP BV848SB Ficha Técnica
(16 páginas)
(16 páginas)
Discos rígidos internos HP FX505AV Ficha Técnica
(74 páginas)
(74 páginas)
Discos rígidos internos HP FX490AV Ficha Técnica
(4 páginas)
(4 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.037 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais