HP 220mx Guia do Utilizador descarregar pdf (Página 356)

Micro/Macro-Moves

HP Surestore Optical Micro-Move IDs

Appendix D D-11

Micro/Macro-Moves

B3 Retract picker plunge assembly back far enough to

release the thumbs and let them go to an unsplayed

position. Used during an ISTAT, and the thumbs are

being returned to an unsplayed position after contacting,

grabbing, and replacing the first cartridge.

B4 Retract picker plunge assembly into the picker to a point

just short of where the thumbs would be released and

unsplay. Used during an ISTAT, and the thumbs are

being retained in the splayed position after contacting,

grabbing, and replacing the first cartridge.

B5 Retract picker plunge assembly far enough to get the

thumbs out of the vertical picker path. Used during an

ISTAT, no cartridge in the picker, and no cartridge was

contacted in the first magazine.

B6 Pull picker plunge assembly fully back to rearm a "put."

Enable the picker to replace the cartridge it picked up

during an ISTAT.

B7 First of two moves that put a cartridge back into the

magazine after the cartridge is detected during an ISTAT.

Moves the cartridge almost fully into the magazine.

Followed by micro-move B8.

B8 Second of two moves that put a cartridge back into the

magazine after the cartridge is detected during an ISTAT.

Moves the cartridge fully into the magazine.

B9 Second of two moves to test for the presence of a cartridge

in a magazine during an ISTAT when there is a cartridge

in the picker. Slow move to check for an overforce

(cartridge in the magazine slot). Follows micro-move BA.

Table D-1 HP Surestore Optical Micro-Move ID Table

(For all models, EXCEPT 40fx, 80ex, 125ex and 220mx)

Move ID

(hex.)

Description

1 2 ... 351 352 353 354 355 356 357 358 359 360 361 ... 377 378

Sem comentários

HP 220mx Guia do Utilizador Página 356